Installation should be correct to help you see the modification error of brake

Today's article describes the actual installation process errors and inferior products. If the brake disc has been installed, please check after reading the article.

The installation position of the brake disc can be determined only by looking at the direction of scribing / drilling on the surface

Not long ago, a friend decided to mark the brake disc and asked the driver to install it. It is said that the installation method of first passing the brake on the outside of the scribing line is correct. It was also said that it was right for the inside of the line to pass the brake first. They all have their own reasons. My friend doesn't know who to listen to.

There are many ways to change the brake, such as punching, scribing, punching + scribing, There are crescent shaped scribing lights, and there are vents on the inside of the brake plate. The function of the brake disc vent is to cool the heat of the brake disc, transfer the hot belt to the vent, and take out the brake pad. The installation method should not only pay attention to the direction of scribing or drilling on the surface, but also pay attention to the direction of the ventilation hole inside the brake. For the civil transformation vehicles, the common installation method is to first pass through the inner side of the flat bottom line. This method can not only remove the brake powder, but also ensure the durability of the brake pad. On the other hand, the outside of the brake line first passes through the calendar. Although this method is better than the previous braking performance, the brake is seriously worn, and the brake pad is seriously worn, The service life of the tablet computer is relatively short. For the brake disc with the vent inclined, generally according to the different vent, "direction" (when it rotates in a square direction, the inside is in the front, and the outside is in the rear). It can be installed in the direction of opening. Of course, some vents are designed in a straight direction. This product can only consider the direction of surface marking and perforation.